The MCP2561-E/SN belongs to the category of integrated circuits (ICs) specifically designed for use in automotive applications.
This product is primarily used as a high-speed CAN transceiver. It provides an interface between a controller area network (CAN) protocol controller and the physical two-wire CAN bus.
The MCP2561-E/SN is typically supplied in tape and reel packaging, with 2500 units per reel.
The MCP2561-E/SN has a total of 8 pins arranged as follows:
┌───┬───┐
│ 1 │ 8 │
└───┴───┘
The MCP2561-E/SN operates based on the Controller Area Network (CAN) protocol. It receives data from a CAN controller and transmits it over the CAN bus using differential signaling. The transceiver also receives data from the bus and forwards it to the controller. It incorporates error detection and reporting mechanisms to ensure data integrity and reliability.
The MCP2561-E/SN is widely used in automotive applications that require reliable and high-speed communication. Some common application areas include:
These alternative models offer similar functionality and can be considered as substitutes for the MCP2561-E/SN in specific applications.
In conclusion, the MCP2561-E/SN is a high-speed CAN transceiver designed for automotive applications. Its robustness, low power consumption, and wide supply voltage range make it suitable for various automotive systems. With its reliable communication interface and built-in protection mechanisms, it ensures efficient data transfer in harsh environments.
What is the maximum data rate supported by MCP2561-E/SN?
- The maximum data rate supported by MCP2561-E/SN is 1 Mbps.
Can MCP2561-E/SN be used in automotive applications?
- Yes, MCP2561-E/SN is suitable for use in automotive applications.
What is the operating voltage range of MCP2561-E/SN?
- The operating voltage range of MCP2561-E/SN is 4.5V to 5.5V.
Is MCP2561-E/SN compatible with CAN FD (Flexible Data-Rate) protocol?
- Yes, MCP2561-E/SN is compatible with CAN FD protocol.
Does MCP2561-E/SN have built-in protection features?
- Yes, MCP2561-E/SN has built-in thermal shutdown and short-circuit protection.
Can MCP2561-E/SN be used in industrial control systems?
- Yes, MCP2561-E/SN is suitable for use in industrial control systems.
What is the typical standby current consumption of MCP2561-E/SN?
- The typical standby current consumption of MCP2561-E/SN is 10 µA.
Is MCP2561-E/SN available in a small form factor package?
- Yes, MCP2561-E/SN is available in an 8-pin SOIC package.
Can MCP2561-E/SN operate in harsh environmental conditions?
- Yes, MCP2561-E/SN is designed to operate in harsh environmental conditions.
Does MCP2561-E/SN support bus fault detection and reporting?
- Yes, MCP2561-E/SN supports bus fault detection and reporting.